Pakker afsendes ikke onsdag den 22/2, men du kan stadig bestille.

kurv 0

Din indkøbskurv er tom.

ArduPilot Main board

Lagerstatus: På lager (1 stk)

Vær den første til at bedømme dette produkt

Arduino-compatible autopilot board
279,00 DKK
Dag-til-dag levering Trustpilot: 9.1+ Fragt fra 39,- Sikker betaling

Del med dine venner

 
Beskrivelse

Detaljer

This is a Arduino-compatible autopilot board designed by Chris Anderson and Jordi Muñoz of DIY Drones using the new ATMega328. This board was used to win the annual autonomous vehicle competition put on by SparkFun.

ArduPilot is a fully programmable autopilot that requires a GPS module and infrared XY and Z sensors to create a functioning Unmanned Aerial Vehicle (UAV). The autopilot handles both stabilization and navigation, eliminating the need for a separate stabilization system. It also supports a "fly-by-wire" mode that can stabilize an aircraft when flying manually under RC control, making it easier and safer to fly. The hardware and software are all open source. The board comes with all the surface-mount parts already soldered, but requires the user to solder on connectors. Firmware is already loaded, but the autopilot software must be downloaded and loaded onto the board by the user. It can be programmed with the Arduino IDE. All details and instructions can be found at the project's home page.

We highly recommend the following items to accompany this product: 

  • An EM406 GPS module
  • An FTDI Basic or FTDI cable for programming
  • An extended EM406 GPS cable
  • An Expansion Board with airspeed sensor
  • XY and Z sensors

Other necessary elements, including aircraft recommendations, can be found at the project's home page.

Bedømmelser

Indsend din bedømmelse

Du anmelder: ArduPilot Main board

Giv produktet karakterer *

  1 stjerne 2 stjerner 3 stjerner 4 stjerner 5 stjerner
Bedømmelse